The digital outputs can drive any kind of device, accordingly with the electrical specifications. This means that the bandwidth is permanently robbed to other devices connected to the same controller;. The status of the relays RA and RB follows the one of the communication. Led indications for Aethra Starmodem. Each doorphone interface contains two relays, RA and RB, whose “normally close” pins are closed and “normally open” pins are open when there is no active communication on the interface default state. Citobox – Rear view.

Uploader: Nizahn
Date Added: 22 August 2007
File Size: 41.1 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 80043
Price: Free* [*Free Regsitration Required]

aethra adsl usb starmodem um | dgpr network

This device allows to exchange data and sms using an UMTS key. Auxiliary pin, leave disconnected if unused connect to 12 V DC in a special BTicino connection scheme in order to provide power to the Microphone line.

The digital outputs are relay-based and have 3 volt free contacts i. Abilis is not driving the device.

One channel device doesn’t require an external power supply. Front Panel and connector pinout. The digital inputs are general purpose, so they can be used to connect any kind of hardware additional ring buttons, digital sensors, etc. The trimmers allow to regulate the volume of the microphone and the speaker clockwise: When a continuous or alternate voltage voltange range 2.

  INTEL QX3 COMPUTER MICROSCOPE DRIVER DOWNLOAD

Citobox – Block scheme. Led indications for Thomson Speedtouch. Note Only the central pins 4,5 and 3,6 are switched!

RJ Switch – Block scheme. It is installed on the board and it’s able to switch each LINE port to the correspondent main port or backup port. The IO part offers 8 digital inputs, 4 digital outputs clean contacts and two analog inputs available only if an analog adaptation module is present.

The digital outputs can drive any kind of device, accordingly with the electrical specifications. If the sim is remote this doesn’t happen; a module resets itself every time a remote sim is connected.

Its digital inputs are only compatible with volt free outputs clean contacts. They are managed by two separated PIC microcontrollers: The communication is cut off when the called party hangs up or when the interface timer expires. Auxiliary pin, leave disconnected if unused connect to MIC in a special BTicino connection scheme, in order to provide power to the Microphone line.

  ADVENT 5431 NETWORK DRIVER

Jumpers configuration is available only in PCB Ver. Citobox – Rear view. Led indications for Aethra Starmodem. Physical and electrical specifications. It provides 8 digital inputs and 4 digital outputs which can be used to drive other hardware to open a gate, to switch uzb lights, etc. Citobox trimmers and pinout. This timer is not programmable and its default value is 10 minutes. Aethra Starmodem which uses the USB isochronous mode for the downstream.

Aethra, SpA. Drivers Download

Connecting a power supply providing more than 5V-DC damages the device! Power is supplied by usb cable ; two channels device require an external 5V-DC power supply.

Each interface of the CITO part is mainly composed of 4 analog pins: Each input of the IO part is separated. Each board allows to plug up to 16 sim cards. AbilisUB Supported starmodeem 7.